IAI R-unit RSEL, Инструкция по эксплуатации, Страница: 271 / 844

Chapter 5 Operation
5.3 Axis Setting
5-6
ME0392-4C
5.3.3 Simple setting method
At the first startup, logical axes are assigned in the order of physical axes in the installed driver
unit.
If you do not need to make any changes, press the Yes button.
To assign logical axes individually, click the No button.
Figure 5.3-1 First startup screen
5.3 Axis Setting
ME0392-4C
5-7
When [Yes] is pressed
The following message will be displayed. Press Yes if you like.
Figure 5.3-2 Confirmation screen for writing to controller
When writing to the flash ROM, the position data is also initialized.
When [No] is pressed
The screen changes to the screen shown in Figure 5.3-2.
Axis assignment can be performed by dragging the actuator image (hereinafter referred to as
axis image) arranged in the physical axis area at the top of the screen and dropping it in the
logical axis area.
To release the axis image assigned in the logical axis area,
• Drag the axis image and drop it in the physical axis area
• Select the axis image and right-
click → “Unassign” or Delete key input
If you want to release them all at once,
• Right-
click in the logical axis area → “Unassign All”
• In the logical axis area, after selecting all with Ctrl + A, press the Delete key
You can cancel with.