IAI R-unit RSEL, Инструкция по эксплуатации, Страница: 243 / 844

Chapter 4 Unit connection / In
stallation and Wiring
4.4 Wiring Method
4-30
ME0392-4C
(4) Have the connector wired in (3) put to the connector allocated on the CC-Link module on the
main unit of RSEL, push the connector till the end, and then tighten it with a slotted screwdriver.
Caution

Conduct the CC-Link wiring on the PLC side following the instruction for the PLC and
master unit to be used.
Tighten it
with slotted
screwdriver
Flathead screwdriver
4.5 PIO Circuit
ME0392-4C
4-31
4.5 PIO Circuit
The connection of I/O to the controller is to be carried out using the dedicated I/O cable. The
cable length is shown in the model code of the controller. Please check the controller model
code. There are 2 m for standard, 3 m and 5 m as an option. Up to 10 m can be enabled sold
separately.
Also, the end of the cable harness to be connected to the host controller (PLC, etc.) is just cut
and no treatment is conducted so the wiring layout can be performed freely.
Model : CB-PAC-PIO 
(  indicates the cable length L. Example. 020 = 2m)
No.
Cable
Color
Wiring No.
Cable
Color
Wiring
1A BR-1
Flat Cable
○
A
(Press Welding)
AWG28
1B BR-3
Flat Cable
○
B
(Press Welding)
AWG28
2A RD-1 2B RD-3
3A OR-1 3B OR-3
4A YW-1 4B YW-3
5A GN-1 5B GN-3
6A BL-1 6B BL-3
7A PL-1 7B PL-3
8A GY-1 8B GY-3
9A WT-1 9B WT-3
10A BK-1 10B BK-3
11A BR-2 11B BR-4
12A RD-2 12B RD-4
13A OR-2 13B OR-4
14A YW-2 14B YW-4
15A GN-2 15B GN-4
16A BL-2 16B BL-4
17A PL-2 17B PL-4
18A GY-2 18B GY-4
19A WT-2 19B WT-4
20A BK-2 20B BK-4