IAI R-unit RSEL, Инструкция по эксплуатации, Страница: 147 / 844

Chapter 3 Specifications for each unit
3.3 200V Power Supply Unit, for 200V Terminal Unit
3-62
ME0392-4C
[Terminal Unit for 200V] RCON-GW-TRS
Item Specifications
External dimensions W12.6 mm × H115 mm × D95 ｍｍ
Mass Approx. 40g
External view See figure below
95
98.8
11
5
12.6
3.4 200V Driver Unit, Fan Unit for 200V Driver
ME0392-4C
3-63
3.4 200V Driver Unit, Fan Unit for 200V Driver
3.4.1 Overview
The 200V driver unit is a unit that connects and controls the 200V system actuators.
The maximum number of axes available to control with one unit of the driver unit is one axis.
It is a controller to perform control in the 200V actuator with SEL program via the SEL unit
explained in 3.1.
The unit is to be installed on the right from the front view of the 200V power supply unit. It is
available to perform control 8 axes at the maximum in combination with the 24V driver unit.
(Note)
Also, there is a 200V fan unit enclosed to the driver unit.
Note: There is a limit to the wattage connectable. Refer to [Characteristics] for details.
[Characteristics]
■ The unit is applicable for the battery -less absolute type, incremental type, index absolute type
and spurious absolute type.
■ One unit of the driver unit can be applied to wattages from 60 to 750W.
■ As it is equipped with a built -in regenerative resistor, there is basically no need of external
regenerative resistor.
■ The wattage connectable is as shown below;
For single-phase 200VꞏꞏꞏꞏꞏꞏꞏꞏꞏTotal wattage of actuators connected to RCON-SC should be
16,00W max.
For 3-phase 200VꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏTotal wattage of actuators connected to RCON-SC should be
24,00W max.
■ Direct link among driver units makes drastically simple wiring work.
■ Installation on DIN rails makes it easy to install to a control board.