Fuji Electric Frenic lift, Справочное руководство

Страница: 67 / 254

■
Run forward – “ FWD ”
(Function code data = 98)
Turning this terminal command ON runs the motor in the forward direction; turning it OFF
decelerates it to stop.
This terminal command “FWD” can be assigned only to E98 or E99.
■
Run reverse – “ REV ”
(Function code data = 99)
Turning this terminal command “REV” ON runs the motor in the reverse direction; turning it OFF
decelerates it to stop.
This terminal command “REV” can be assigned only to E98 or E99.
■
No function assigned – “ NONE ” (Function code data = 100)
(Function code data = 100)
It allows the inverter to run unaffected by ON/OFF of signals. It is used when a signal is externally
input using customizable logic. It is also used to temporarily disable a terminal function.
■
External alarm 2 – THR2
(Function code data = 101)
Before the alarm will happen, if inverter keeps driving for ten seconds. When the inverter shut down
the output within ten seconds, alarm will happen.
 For details, refer to the descriptions of function codes L98 (bit1).
■
Start reference torque decreasing – RTDEC
(Function code data = 102)
The inverter decreases reference torque to initial torque bias, when turning RTDEC command OFF.
 For details, refer to the descriptions of function codes L99 (bit2).
■
Output MC confirmation – CS-MC
(Function code data = 103)
The correct operation of the output functions SW52-2 and SW52-3 can be confirmed by this
function.
 For details, refer to the descriptions of function codes L84 to L86.
■
CAN Enable – CAN_LE
(Function code data = 108)
When CAN_LE is turned on, the CAN communication becomes effective.
■
Check brake control 1 – BRKE1 (Function code data = 111)
Check brake control 2 – BRKE2 (Function code data = 112)
Motor brakes are expected to work according
BRKS
output from the inverter.
These terminal commands are used to monitor the brake operation (status) according to
the requirements of Unintended Car Movement as prescribed in EN 81-1:1998 +
A3:2009 9.11.3. Use certified motor brakes microswitches to turn these terminal
commands ON or OFF when brakes are released or applied respectibelly.
 For details, refer to the descriptions of function codes L80 to L84 (Brake Control) and H96.
For additional information, refer to related Application Note (AN-Lift2-0002v100EN).
2-54