Fuji Electric Frenic lift, Справочное руководство

Страница: 54 / 254

2.3 Overview of Function Code
C
hap.
2
FUN
CT
IO
N
C
O
D
E
S
■
Start control mode (L52)
The soft start is available in two start control modes: Speed start and torque start modes. L52 selects
the start control mode.
Start control mode
(L52)
Multistep speed
command
* 1
(F01 = 0)
Analog speed command
(Not reversible)
(F01 = 1)
Analog speed command
(Reversible)
* 2
(F01 = 2)
Speed start mode
(L52 = 0)
Y Y N
* 4
Torque start mode
(L52 = 1)
Y N
* 3
N
* 4
* 1
Including keypad command operations and jogging operation
* 2
Including commands entered via a communications link
* 3
Functionally equivalent to the operation with L52 = 0.
* 4
Soft start to the starting speed is disabled.
Once the inverter speed decreases to less than the stop speed, increasing the reference
speed (pre-ramp) with a run command being ON does not activate a soft start to the
starting speed. To soft start the motor up to the starting speed, turn the run command
OFF once.
■
In case of Vector control with PG
Speed start mode
Setting L52 data to "0" enables the speed start mode.
(i) When a multistep speed command with S-curve acceleration/deceleration is enabled (F01 = 0)
If the reference speed (pre-ramp) exceeds the starting speed, the inverter activates a soft start to the
starting speed. After starting speed holding time (F24) is elapsed, the inverter accelerates up to the
reference speed (pre-ramp).
If stop speed set value (F25) is higher than starting speed set value (F23), the inverter
does not activate a soft start as long as the reference speed (pre-ramp) does not exceed
the stop speed.
Speed
0
High Speed
Stating Speed
FWD
SS1
SS2
SS4
ON
ON
ON
ON
H64=0.00 s
E12: Acceleration/
deceleration time 6
L19
S-curve setting
L24
S-curve setting
SW52-2
ON
Output Gate ON
L85
Zero
Speed
(C04)
H65 F24
Speed
0
High Speed
Stating Speed
FWD
SS1
SS2
SS4
ON
ON
ON
ON
H64 ≠ 0.00 s
E12: Acceleration/
deceleration time 6
L19
S-curve setting
L24
S-curve setting
SW52-2 ON
Output Gate
ON
L85 H64 H65 F24
2-41