Endress+Hauser Proline Cubemass 300, Описание параметров устройства

Страница: 146 / 294

Description of device parameters Proline Cubemass 300 Modbus RS485
146 Hauser
Factory setting Mass flow
Assign status 
Navigation  Expert → Output → PFS output 1 to n → Assign status (0485–1 to n)
Prerequisite • The Switch option is selected in the Operating mode parameter (→  126).
• The Status option is selected in the Switch out funct parameter (→  141).
Description Use this function to select a device status for the switch output.
Selection • Partial pipe det
• Low flow cut off
Factory setting Partial pipe det
Additional information Options
If empty pipe detection or low flow cut off are enabled, the output is conductive.
Otherwise, the switch output is non-conductive.
Switch-on delay 
Navigation  Expert → Output → PFS output 1 to n → Switch-on delay (0467–1 to n)
Prerequisite • The Switch option is selected in the Operating mode parameter (→  126).
• The Limit option is selected in the Switch out funct parameter (→  141).
Description Use this function to enter a delay time for switching on the switch output.
User entry 0.0 to 100.0 s
Factory setting 0.0 s
Switch-off delay 
Navigation  Expert → Output → PFS output 1 to n → Switch-off delay (0465–1 to n)
Prerequisite • The Switch option is selected in the Operating mode parameter (→  126).
• The Limit option is selected in the Switch out funct parameter (→  141).
Description Use this function to enter a delay time for switching off the switch output.
User entry 0.0 to 100.0 s
Factory setting 0.0 s