Endress+Hauser Proline Cubemass 300, Описание параметров устройства

Страница: 83 / 294

Proline Cubemass 300 Modbus RS485 Description of device parameters
Hauser 83
Assign variable 
Navigation  Expert → Sensor → Process param. → Partial pipe det → Assign variable (1860)
Description Use this function to select a process variable to detect empty or partially filled measuring
tubes.
For gas measurement: Deactivate monitoring due to low gas density.
Selection • Off
• Density
• Ref.density
Factory setting Off
Low value 
Navigation  Expert → Sensor → Process param. → Partial pipe det → Low value (1861)
Prerequisite One of the following options is selected in the Assign variable parameter (→  83):
• Density
• Ref.density
Description Use this function to enter a lower limit value to enable detection of empty or partially filled
measuring tubes. If the measured density falls below this value, monitoring is enabled.
User entry Signed floating-point number
Factory setting 200
Additional information User entry
The lower limit value must be less than the upper limit value defined in the High value
parameter (→  83).
The unit depends on the process variable selected in the Assign variable parameter
(→  83).
Limit value
If the displayed value is outside the limit value, the measuring device displays the
diagnostic message S862 Partly filled .
High value 
Navigation  Expert → Sensor → Process param. → Partial pipe det → High value (1858)
Prerequisite One of the following options is selected in the Assign variable parameter (→  83):
• Density
• Ref.density