7-6
FRX8000 3. 0 User G uide, Rev 02
1
FR
is frame relay, and is valid only on FRX8000 ports.
2
If
PVC
is
Y
, leave
Cal led Address
and
Calli ng Address
blank. Also,
PVC
must be
N
if
other end of trunk will be an N74/7500.
3
Must be
1
if other end of trunk will be an N74/7500. (See explanation.)
4
The connection defined by the card, port, and DLCI must be different for each logical
connection (logical port, IP or IPX interface over frame relay, and frame relay-to-frame
relay PVC) in this node.
5
This Trunk a Backup
and
This Trunk Backed Up
cannot both be
Y
. If one is
Y
, changing
the other to
Y
will automatically change the first one to
N
.
Physical Interface
is the hardware interface. On an AST LP, this is always RS-232. On an RLP, the
interface is determined by the associated Line Interface Card (LIC) and the cable
attached to the port's I/O box connector. The LP record identifies the LIC, and only
the valid interfaces will be displayed as choices in the Port record. LICs are shown in
parentheses:
3
= RS-232 (RS-232)
4
= V.25Bis_Dial (RS-232)
5
= V.35 (V.35)
6
= RS-449 (RS-422)
7
= RS-530 (RS-422)
8
= X.21 (RS-422)
9
= E1 (E1)
Blocked Port Flag
causes the port to be enabled (
N
) or disabled (
Y
) at node
IPL
. The port will remain in
that state until this parameter is changed (and sent to the node) or an on-line enable/
disable is performed. (See "
Disabling and Enabling Ports"
on page 18-1.)
Line Speed Code
specifies the data transmission rate in bits per second, and the clock speed when the
port is a physical DCE. If this port is not configured to generate clock, specify the line
speed that corresponds (as closely as possible) to the configuration of the device con-
nected to the port. Line speed codes are as follows. (Some speeds have two corre-
Logical Trunk Parameters
Underlying Physical Por t
valid X.25 or FR port
1
none
Cal ling Addr ess
valid subscriber ID
2
none
Cal led Address
valid subscriber ID
2
none
Number of Circuits
1–8
3
1
PVC
Y/N
2
N
First PVC LCN
(to be implemented in a future release)
Mapped DLCI Number
16–991
4
none
Connection Priority
0–9
0
Backup Trunk Parameters
This Trunk a Backup
5
Y/N
N
De-Activation Timer
(sec)
1-300
20
This Trunk Backed Up
5
Y/N
N
Backup LP ID
0-7
0
Backup Port No
.
0-3
0
Backup Logical Trunk
1-8
1
Table 7-1 Trunk Port Parameters
Parameter
Valid Values
Default Value
(continued)
Содержание Netlink FRX8000
