6-6
FRX8000 3. 0 User G uide, Rev 02
International Use Bit 1
is the setting of bit 1, which is transmitted as the most significant bit of the non-frame
alignment signal when CRC-4 is disabled.
N7000 RLP
The N7000 (N7400/7500) RLP is supported only in N7400 and N7500
nodes.
The N7000 RLP is nearly identical to the FRX8000 RLP, shown in
Figure 5-1
.
To configure an LP record, press
[C]
at the Line Processor Configuration Menu (or
[A], [C], [C]
from the Main Menu). When prompted, enter:
●
Node ID
(the node containing the LP):
1–250
. (Default is the “local” node).
●
LP ID
:
0–7
(default is
0
.), as determined by switches 1–3 on the RLP’s dipswitch.
(See
Table 5-1
.)
●
Any other requested information, noting the values in
Table 5-2
. (Press
[Enter]
at a prompt to specify the default.)
Figure 6-3 N7400/7500 RLP Configuration Record
[A],[C],[C]
from Main Menu
Line Proces sor Main ten ance
*
N ode ID
10
*
LP I D
1
A LP Typ e
6
N74/7500 R LP
B Line I nterface C ard 1:
1
RS-232
C Line I nterface C ard 2:
1
RS-232
Select:
Содержание Netlink FRX8000
