Bull Escala BL460, Руководство по диагностике и обслуживанию, Страница: 57 / 266

Chapter 2. Diagnostics
37
• Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved. If an action solves the problem, then you can stop performing the remaining actions.
•
See Chapter 3 , “ Parts listing ,” on page 197 to determine which components are CRUs and which
components are FRUs.
B200 xxxx
Error codes
Description Action
8114
During the startup of a partition, there was
a failure verifying the VPD for the partition
resources during startup.
Check for server firmware updates; then, install the updates
if available.
8115
During the startup of a partition, there was
a low level
partition-to-partition communication failure.
Check for server firmware updates; then, install the updates
if available.
8117
During the startup of a partition, the
partition did not start up due to a system
firmware error.
Check for server firmware updates; then, install the updates
if available.
8121
During the startup of a partition, the
partition did not start up due to a system
firmware error.
Go to “ Firmware problem isolation ” on page 185 .
8123
During the startup of a partition, the
partition did not start up due to a system
firmware error.
Go to “ Firmware problem isolation ” on page 185 .
8125
During the startup of a partition, the
partition did not start up due to a system
firmware error.
Go to “ Firmware problem isolation ” on page 185 .
8127
During the startup of a partition, the
partition did not start up due to a system
firmware error.
Go to “ Firmware problem isolation ” on page 185 .
8129
During the startup of a partition, the
partition did not start up due to a system
firmware error.
Go to “ Firmware problem isolation ” on page 185 .
813A
There was a problem establishing a
console.
Go to “ Firmware problem isolation ” on page 185 .
8140 Informational system log entry only. No corrective action is required.
8141 Informational system log entry only. No corrective action is required.
8142 Informational system log entry only. No corrective action is required.
8143 Informational system log entry only. No corrective action is required.
8144 Informational system log entry only. No corrective action is required.
8145 Informational system log entry only. No corrective action is required.
8150 System firmware detected an error.
Collect a platform dump and then go to “ Firmware problem
isolation ” on page 185 .
8151 System firmware detected an error.
Use the Integrated Virtual Manager (IVM) to increase the
Logical Memory Block (LMB) size, and to reduce the number
of virtual devices for the partition.
8152 No active system processors. Verify that processor resources are assigned to the partition.
8160
A problem occurred during the migration of
a partition.
Contact Bull support, as described in Appendix A, “ Getting
Help and Technical Assistance ”, on page 239.
8161
A problem occurred during the migration of
a partition.
Contact Bull support, as described in Appendix A, “ Getting
Help and Technical Assistance ”, on page 239.
A100
A partition ended abnormally; the partition
could not stay running and shut itself down.
1. Check the error logs and take the actions for the error
codes that are found.
2. Go to “ Firmware problem isolation ” on page 185 .
A101
A partition ended abnormally; the partition
could not stay running and shut itself down.
1. Check the error logs and take the actions for the error
codes that are found.
2. Go to “ Firmware problem isolation ” on page 185 .
A140
A lower priority partition lost a usable
processor to supply it to a higher priority
partition with a bad processor.
Evaluate the entire LPAR configuration. Adjust partition
profiles with the new number of processors available in the
system.
B07B Informational system log entry only. No corrective action is required.