Bull Escala BL460, Руководство по диагностике и обслуживанию, Страница: 236 / 266

216
Escala BL460 - Problem Determination and Service Guide
4.4.9 Removing the management card
Remove the management card.
Figure 4-11.
Removing the management card
Perform the following procedure to remove the management card, which is shown by ( 1 )
in the figure above.
1. Read “ Safety ” on page vii and the “ Installation guidelines ” on page 201 .
2. Shut down the operating system, turn off the blade server, and remove the blade
server from the Bull Blade Chassis - Enterprise. See “ Removing the blade server from a
Bull Blade Chassis - Enterprise ” on page 203 .
3. Carefully lay the blade server on a flat, static-protective surface, with the cover side
up.
4. Open and remove the blade server cover. See “ Removing the blade server cover ”, on
page 206.
5. Locate the management card connector.
See “
System-board connectors ” on page 12 for the management card slot location.
Attention: To avoid breaking the card retaining clips ( 2 ) or damaging the
management card connectors, open and close the clips gently.
6. Carefully open the retaining clips on each end of the management card connector and
remove the management card.
7. If you are instructed to return the management card, follow all packaging instructions,
and use any packaging materials for shipping that are supplied to you.
8. Move the management card to a new system board and chassis assembly.
If you are directed to move the management card to a new system board and chassis
assembly, perform the following procedure.
a.
Replace the system board and chassis assembly, as described in
“
Replacing the
Tier 2 system-board and chassis assembly
” on page 229
.
b. Replace the management card, as described in “ Installing the management card ”
on page 217 .