Bull Escala BL460, Руководство по диагностике и обслуживанию, Страница: 238 / 266

218
Escala BL460 - Problem Determination and Service Guide
7. Install and close the blade server cover. See “Installing and closing the blade server
cover” on page 208 .
Statement 21
CAUTION:
Hazardous energy is present when the blade server is connected to the power
source. Always replace the blade server cover before installing the blade server.
8. Install the blade server into the Bull Blade Chassis - Enterprise. See Installing the blade
server in a Bull Blade Chassis - Enterprise , on page 204 .
Because the system board and chassis assembly has not changed, the firmware
initializes the management card VPD using data that the blade server cached.
To ensure that you give the initialization enough time to complete, access the
management module and wait for the management module to discover the blade
server.
Attention
:
If the management card was not properly installed, the power-on LED blinks
rapidly and a communication error is reported to the management module. If this
occurs, remove the blade server from the Bull Blade Chassis - Enterprise, as described
in “ Removing the management card ” on page 216 . Reseat the management card,
then reinstall the blade server in the Bull Blade Chassis - Enterprise.
9. Complete this procedure before installing a new system board. Then, you can install
the new system board by performing the following procedure:
a.
Shut down the operating system, turn off the blade server, and remove the blade
server from the Bull Blade Chassis - Enterprise. See “ Removing the blade server
from a Bull Blade Chassis - Enterprise ” on page 203 .
b. Perform the procedure for replacing the system board to install the new system
board. See “ Replacing the Tier 2 system-board and chassis assembly ” on page
229 .