Bull Escala BL460, Руководство по диагностике и обслуживанию, Страница: 247 / 266

Chapter 4. Removing and replacing blade server components
227
7. Make sure that the boot list is correct using the management module Web interface.
See the management module documentation for more information) or the SMS Utility.
See “Using the SMS utility” on page 263 for more information.
4.4.14 Removing the disk drive tray
You can remove the hard disk drive tray.
Figure 4-19.
Removing the hard disk drive tray
Perform the following procedure to remove the hard disk drive tray.
1. Read “ Safety ” on page vii and the “ Installation guidelines ” on page 201 .
2. Shut down the operating system, turn off the blade server, and remove the blade
server from the Bull Blade Chassis - Enterprise. See “ Removing the blade server from a
Bull Blade Chassis - Enterprise ” on page 203 .
3. Carefully lay the blade server on a flat, static-protective surface, with the cover side
up.
4. Open and remove the blade server cover. See “ Removing the blade server cover ”, on
page 206.
5. Remove the hard disk drive if one is installed. See “ Removing a drive ” on page 211 .
6. Remove the four screws that secure the drive tray to the system board and remove the
drive tray.
Save the screws that secure the tray to the system board. Store the screws in a safe place.