Bull Escala BL460, Руководство по диагностике и обслуживанию, Страница: 170 / 266

150
Escala BL460 - Problem Determination and Service Guide
Step 004
Is the operating system Linux?
Yes Record any information or messages that may be in the management module event
log; then go to Step 007. If you cannot load the stand-alone Diagnostics CD, answer this
question No .
No Go to “ Solving undetermined problems ” on page 194 .
Step 005
Perform the following steps:
Note When possible, run AIX online diagnostics in concurrent mode. AIX online diagnostics
perform more functions than the stand-alone diagnostics.
1. Perform the AIX online diagnostics, see “ Starting AIX concurrent diagnostics ” on page
152 . Record any diagnostic results and see the “ Service request numbers (SRNs) ” on
page 109 to identify the failing component.
Note: When replacing a component, perform system verification for the component.
See Using the diagnostics program ” on page 155 .
2. If you cannot perform AIX concurrent online diagnostics, continue to Step 006.
Step 006
Perform the following steps:
1. Use the management-module Web interface to make sure that the device from which
you load the stand-alone diagnostics is set as the first device in the blade server boot
sequence.
2. Turn off the system unit power and wait 45 seconds before proceeding.
3. Turn on the blade server and establish a SOL session.
4. Check for the following responses:
a.
Progress codes are recorded in the management-module event log.
b. Record any messages or diagnostic information that might be in the log.
5. Load the stand-alone diagnostics. Go to “ Starting stand-alone diagnostics from a CD ”
on page 152 or “ Starting stand-alone diagnostics from a NIM server ” on page 153 .
6. If you have replaced the failing component, perform system verification for the
component. See Using the diagnostics program ” on page 155 .
This ends the AIX procedure.