Bull Escala BL460, Руководство по диагностике и обслуживанию, Страница: 164 / 266

144
Escala BL460 - Problem Determination and Service Guide
SRN FFC Description and action
ssss-137 ssss 252B
Unit attention condition has occurred on the Send Diagnostic command.
1. Check the management-module event log. If an error was recorded by the system,
see “ POST progress codes (checkpoints) ” on page 71 .
2. Replace any parts reported by the diagnostic program.
3. Replace the system board and chassis assembly, as described in “
Replacing the Tier
2 system-board and chassis assembly ” on page 229 .
ssss-138 ssss
Error log analysis indicates that the disk drive is operating at a higher than
recommended temperature.
1. Make sure that:
−
The ventilation holes in the blade server bezel are not blocked.
−
The management-module event log is not reporting any system environmental
warnings.
2. If the problem remains, call Bull support.
ssss-140
199 252B
ssss
Error log analysis indicates poor signal quality.
1. Check the management-module event log. If an error was recorded by the system,
see “ POST progress codes (checkpoints) ” on page 71 .
2. Replace any parts reported by the diagnostic program.
3. Replace the system board and chassis assembly, as described in “
Replacing the Tier
2 system-board and chassis assembly ” on page 229 .
ssss-640 ssss
Error log analysis indicates a path error.
1. Check the management-module event log. If an error was recorded by the system,
see “ POST progress codes (checkpoints) ” on page 71 .
2. Replace any parts reported by the diagnostic program.
3. Replace the system board and chassis assembly, as described in “
Replacing the Tier
2 system-board and chassis assembly ” on page 229 .
2.4.3.5 Failing function codes 151 through 2D02
Failing function codes (FFCs) identify a function within the system unit that is failing.
Table 26 describes the component that each function code identifies.
Note: When replacing a component, perform system verification for the
component. See “ Using the diagnostics program ” on page 155 .
Table 2-26.
Failing function codes 151 through 2D02
FFC
Description and notes
151
1. Battery
Note: After replacing the battery:
a. Set the time and date.
b. Set the Network IP addresses (for blade servers that start up from a network).
2. System-board and chassis assembly
152
System-board and chassis assembly
166
Check management-module event log for a blower or fan fault. See the documentation that comes
with the Bull Blade Chassis - Enterprise.
210
System-board and chassis assembly
212
System-board and chassis assembly (cache problem)