Bull Escala BL460, Руководство по диагностике и обслуживанию, Страница: 31 / 266

Chapter 1. Introduction
11
1.7 Turning off the blade server
When you turn off the blade server, it is still connected to power through the Bull Blade
Chassis - Enterprise. The blade server can respond to requests from the service processor,
such as a remote request to turn on the blade server. To remove all power from the blade
server, you must remove it from the Bull Blade Chassis - Enterprise.
Shut down the operating system before you turn off the blade server. See the operating-
system documentation for information about shutting down the operating system.
You can turn off the blade server in one of the following ways.
• Turn off the blade server by pressing the power-control button for at least 5 seconds.
The power-control button is on the blade server behind the control panel door.
See Blade server control panel buttons and LEDs on page 7 for the location.
Note The power-control LED can remain on solidly for up to 1 minute after you push the
power-control button. After you turn off the blade server, wait until the power-control
LED is blinking slowly before you press the power-control button to turn on the blade
server again
If the operating system stops functioning, press and hold the power-control button for
more than 5 seconds to force the blade server to turn off.
• Use the management module to turn off the blade server.
The power-control LED can remain on solidly for up to 1 minute after you initiate the
power-off process. After you turn off the blade server, wait until the power-control LED
is blinking slowly before you initiate the power-on process from the AMM to turn on
the blade server again.
Use the management-module Web interface to configure the management module to
turn off the blade server if the system is not operating correctly.
For additional information, see the User’s Guide for the management module.