![background image](http://html1.mh-extra.com/html/abb/acs880-x04/acs880-x04_firmware-manual_3389539265.webp)
Parameters 265
Defines the maximum allowed speed.
WARNING!
This value must not be lower than
WARNING!
In frequency control mode, this limit is not
effective. Make sure the frequency limits (
) are set appropriately if frequency control is
used.
WARNING!
In a master/follower configuration, do not
set maximum and minimum speed limits with the same
sign on a follower drive. See section
(page
1500.00 rpm;
1800.00 rpm
(
b0)
-30000.00 …
30000.00 rpm
Maximum speed.
See par.
Defines the minimum allowed frequency.
WARNING!
This value must not be higher than
.
WARNING!
This limit is effective in frequency control
mode only.
-50.00 Hz;
-60.00 Hz
(
b0)
-500.00 … 500.00
Hz
Minimum frequency.
See par.
Defines the maximum allowed frequency.
WARNING!
This value must not be lower than
.
WARNING!
This limit is effective in frequency control
mode only.
50.00 Hz;
60.00 Hz
(
b0)
-500.00 … 500.00
Hz
Maximum frequency.
See par.
A temporary motor current limit specifically for starting can be
defined by this parameter and
.
, the drive observes the
start current limit defined by
. The
limit is in force for 2 seconds after initial magnetization (of an
asynchronous induction motor) or autophasing (of a
permanent magnet motor), but not more often than once in
every 7 seconds. Otherwise, the limit defined by
Note:
The availability of a start current higher than the general
limit depends on drive hardware. See the rating data in the
hardware manual of the drive.
Disable
Start current limit disabled.
0
Enable
Start current limit enabled.
1
Defines a maximum start current when enabled by parameter
-
0.00 … 30000.00 A Maximum start current.
1 = 1 A
Defines the maximum allowed motor current.
0.00 A
0.00 … 30000.00 A Maximum motor current.
1 = 1 A
No.
Name/Value
Description
Def
/
FbEq16
Содержание ACS880-x04
