![background image](http://html1.mh-extra.com/html/abb/acs880-x04/acs880-x04_firmware-manual_3389539308.webp)
308 Parameters
Displays the percentage of samples recorded by amplitude
logger 2 that fall between 60 and 70%.
0.00%
0.00 … 100.00%
Amplitude logger 2 samples between 60 and 70%.
1 = 1%
Displays the percentage of samples recorded by amplitude
logger 2 that fall between 70 and 80%.
0.00%
0.00 … 100.00%
Amplitude logger 2 samples between 70 and 80%.
1 = 1%
Displays the percentage of samples recorded by amplitude
logger 2 that fall between 80 and 90%.
0.00%
0.00 … 100.00%
Amplitude logger 2 samples between 80 and 90%.
1 = 1%
Displays the percentage of samples recorded by amplitude
logger 2 that exceed 90%.
0.00%
0.00 … 100.00%
Amplitude logger 2 samples over 90%.
1 = 1%
Displays the date on which amplitude logger 2 was last reset.
-
-
Last reset date of amplitude logger 2.
-
Displays the time at which amplitude logger 2 was last reset.
-
-
Last reset time of amplitude logger 2.
-
37
Settings for user load curve.
See also section
(page
Displays the status of the monitored signal. (The status word
is independent of the actions and delays selected by
parameters
,
.)
This parameter is read-only.
-
000b … 101b
Status of the monitored signal.
1 = 1
Selects the signal to be monitored. The function compares the
absolute value of the signal against the load curve.
Not selected
No signal selected (monitoring disabled).
0
Motor current %
(see page
2
Motor torque %
(see page
3
Output power % of
motor nominal
).
4
). -
Selects how the drive reacts if the absolute value of the
monitored signal stays above the overload curve for longer
than the value of
.
Disabled
No action taken.
0
Warning
The drive generates a warning (
). 1
Fault
2
No.
Name/Value
Description
Def
/
FbEq16
Bit
Name
Information
0
Under load limit
1 = Monitored signal is below the underload curve
1
Reserved
2
Over load limit
1 = Monitored signal is above the overload curve
3…15
Reserved
Содержание ACS880-x04
