196 Parameters
No
Local control enabled.
0
Yes
Local control disabled.
1
Selects the reference type for scalar motor control mode.
See also section
(page
), and
parameter
.
Note:
This parameter cannot be changed while the drive is
running.
Hz
Hz. The reference is taken from parameter
(output of the frequency control chain).
0
Rpm
Rpm. The reference is taken from parameter
(speed reference after ramping and shaping).
1
20
Start/stop/direction and run/start/jog enable signal source
selection; positive/negative reference enable signal source
selection.
For information on control locations, see section
Selects the source of start, stop and direction commands for
external control location 1 (EXT1).
See also parameters
Not selected
No start or stop command sources selected.
0
In1 Start
The source of the start and stop commands is selected by
parameter
. The state transitions of the
source bits are interpreted as follows:
1
In1 Start; In2 Dir
is the start
signal; the source selected by
determines the direction. The state transitions of the source
bits are interpreted as follows:
2
No.
Name/Value
Description
Def
/
FbEq16
State of source 1
(
)
Command
0?1 (
1 (
Start
0
Stop
State of source 1
)
State of source 2
)
Command
0
Any
Stop
0?1 (
0
Start forward
1
Start reverse
Содержание ACS880-x04
