![background image](http://html1.mh-extra.com/html/abb/acs880-x04/acs880-x04_firmware-manual_3389539063.webp)
Program features 63
DC magnetization
DC magnetization can be applied to the motor to
• heat the motor to remove or prevent condensation, or
• to lock the rotor at, or near, zero speed.
Pre-heating
A motor pre-heating function is available to prevent condensation in a stopped motor,
or to remove condensation from the motor before start. Pre-heating involves feeding
a DC current into the motor to heat up the windings.
Pre-heating is deactivated at start, or when one of the other DC magnetization
functions is activated. With the drive stopped, pre-heating is disabled by the safe
torque off function, a drive fault state, or the process PID sleep function. Pre-heating
can only start after one minute has elapsed from stopping the drive.
A digital source to control pre-heating is selected by parameter
. The heating current is set by
.
Pre-magnetization
Pre-magnetization refers to DC magnetization of the motor before start. Depending
on the selected start mode (
), pre-
magnetization can be applied to guarantee the highest possible breakaway torque,
up to 200% of the nominal torque of the motor. By adjusting the pre-magnetization
time (
), it is possible to synchronize the motor start and, for
example, the release of a mechanical brake.
DC hold
The function makes it possible to lock the rotor at (near) zero speed in the middle of
normal operation. DC hold is activated by parameter
. When
both the reference and motor speed drop below a certain level (parameter
), the drive will stop generating sinusoidal current and start to inject DC
into the motor. The current is set by parameter
. When the
reference exceeds parameter
, normal drive operation
continues.
Содержание ACS880-x04
