![background image](http://html1.mh-extra.com/html/abb/acs880-x04/acs880-x04_firmware-manual_3389539114.webp)
114 Parameters
Terms and abbreviations
Term
Definition
Actual signal
Type of
that is the result of a measurement or calculation by the drive, or
contains status information. Most actual signals are read-only, but some (especially
counter-type actual signals) can be reset.
Def
(In the following table, shown on the same row as the parameter name)
The default value of a
when used in the Factory macro. For information on
other macro-specific parameter values, see chapter
(page
).
Note:
Certain configurations or optional equipment may require specific default values.
These are labelled as follows:
(
bx) = Default changed or write-protected by parameter
, bit x.
FbEq16
(In the following table, shown on the same row as the parameter range, or for each
selection)
16-bit fieldbus equivalent: The scaling between the integer used in communication and
the value shown on the panel when a 16-bit value is selected for transmission to an
external system.
A dash (-) indicates that the parameter is not accessible in 16-bit format.
The corresponding 32-bit scalings are listed in chapter
(page
Other
The value is taken from another parameter.
Choosing “Other” displays a parameter list in which the user can specify the source
parameter.
Note:
The source parameter must be of the
(32-bit floating point) type. To use a
16-bit integer (for example, received from an external device in data sets) as the source,
data storage parameters
(page
) can be used. The parameter types are
(page
Other [bit]
The value is taken from a specific bit in another parameter.
Choosing “Other” displays a parameter list in which the user can specify the source
parameter and bit.
Parameter
Either a user-adjustable operating instruction for the drive, or an
.
p.u.
Per unit
Содержание ACS880-x04
