![background image](http://html1.mh-extra.com/html/abb/acs880-x04/acs880-x04_firmware-manual_3389539427.webp)
Parameters 427
Provides status information on the user data logger (see page
This parameter is read-only.
0000b
0000b…1111b
User data logger status word.
1 = 1
Triggers, or selects a source that triggers, the user data
logger.
Off
0.
0
On
1.
1
Source selection (see
). -
Starts, or selects a source that starts, the user data logger.
Off
0.
0
On
1.
1
Source selection (see
). -
Factory data logger
time level
Selects the sampling interval for the factory data logger (see
page
).
500us
500 microseconds.
500
2ms
2 milliseconds.
2000
10ms
10 milliseconds.
10000
Disables/enables the adaptive program (if present).
See also section
(page
).
Note:
This parameter cannot be changed while the drive is
running.
No
Adaptive program enabled.
0
Yes
Adaptive program disabled.
1
(Visible when user lock is open)
To change the current user pass code, enter a new code into
this parameter as well as
. A
warning will be active until the new pass code is confirmed. To
cancel changing the pass code, close the user lock without
confirming. To close the lock, enter an invalid pass code in
parameter
, activate parameter
, or cycle the power.
See also section
(page
10000000
10000000…
99999999
New user pass code.
-
No.
Name/Value
Description
Def
/
FbEq16
Bit
Name
Description
0
Running
1 = The user data logger is running. The bit is cleared after the post-trigger
time has passed.
1
Triggered
1 = The user data logger has been triggered. The bit is cleared when the
logger is restarted.
2
Data
available
1 = The user data logger contains data that can be read. Note that the bit is
not cleared because the data is saved to the memory unit.
3
Configured
1 = The user data logger has been configured. Note that the bit is not
cleared because the configuration data is saved to the memory unit.
4…15
Reserved
Содержание ACS880-x04
