![background image](http://html1.mh-extra.com/html/abb/acs880-x04/acs880-x04_firmware-manual_3389539523.webp)
Fault tracing 523
0002 Motor is rotating during
autophasing.
Check that the motor is not already
rotating when the autophasing routine
starts.
0003 Too much difference between
measured and estimated
positions
Check that encoder is not slipping.
Check parameter
several times to
verify that the autophasing routine gives
consistent results.
Check the motor model parameters.
0004 Rotor did not rotate as
expected between zero pulses.
Check that the zero pulses are given
correctly.
0005 Position estimate did not
stabilize.
Check that the selected mode
(parameter
) is appropriate for the
motor.
0006 Measured position status
information changed.
Check that parameter
is not
changed to
during the routine.
0007 General autophasing failure
Contact your local ABB representative.
0008 Selected mode not supported.
Check that the selected mode
(parameter
) is supported by the
motor type.
0009 (LV-Synchro) Standstill failure.
Contact your local ABB representative.
4000
Motor cable overload
Calculated motor cable
temperature has exceeded
warning limit.
Check the settings of parameters
Check the dimensioning of the motor
cable in regard to required load.
4210
IGBT overtemperature Estimated drive IGBT
temperature is excessive.
Check ambient conditions.
Check air flow and fan operation.
Check heatsink fins for dust pick-up.
Check motor power against drive power.
4290
Cooling
Drive module temperature is
excessive.
Check ambient temperature. If it exceeds
40 °C (104 °F), ensure that load current
does not exceed derated load capacity of
drive. See appropriate
Hardware manual.
Check drive module cooling air flow and
fan operation.
Check inside of cabinet and heatsink of
drive module for dust pick-up. Clean
whenever necessary.
42F1
IGBT temperature
Drive IGBT temperature is
excessive.
Check ambient conditions.
Check air flow and fan operation.
Check heatsink fins for dust pick-up.
Check motor power against drive power.
4310
Excess temperature
Power unit module
temperature is excessive.
(page
).
4380
Excess temperature
difference
High temperature difference
between the IGBTs of different
phases.
(page
).
Code
(hex)
Fault
Cause
What to do
Содержание ACS880-x04
