ADDENDUM TO THE CFW-10 FREQUENCY INVERTER USER MANUAL
CFW-10 COLD PLATE
08/2006
ATTENTION!
Information presented in this addendum applies only to CFW-10 models with special hardware (CP). hence, check
if the “CP” tag appears on the intelligent code of the product identification sticker.
This special hardware “CP” was designed in order to allow mounting the “CP” CFW-10 frequency inverter in any heat
dissipation surface, since following recommendations are fulfilled.
INSTALLATING THE FREQUENCY INVERTER ON THE HEAT DISSIPATION SURFACE - STEPS.
1.
Mark out the positions of the mounting holes on the backing plate where the frequency inverter will be located (see in
figure 1 drawing and hole size).
2.
The surface that is in contact with frequency inverter dissipation surface must be free of dirt and burr. Standard
requirements are: The backing plate flatness (considering an area of 100mm
2
)
shall be less than 50
μ
m and the
roughness less than 10
μ
m.
3.
Use (M4) mounting screws in order to fasten the frequency inverter to the base plate
MOUNTING BASE VIEW FRONTAL VIEW SIDE VIEW
Figure 1
– Dimensional and mounting holes
4.
After drilling the holes, clean the contact surface of the backing plate and coat it with a thin thermal paste layer, or with a
heat conducting foil or similar product (approx. 100
μ
m).
5.
Continue the mechanical installation as indicated in Chapter 3.1 of the frequency inverter user manual.
Note!
Table 3.2 of the user manual shall not be considered for this special frequency inverter. External dimensions a
mounting holes are according to the figures of this addendum.
6.
Electrical installation shall be performed as indicated in the Chapter 3.2 of the frequency inverter user manual.
ATTENTION!
After operation, check P008. This parameter must not exceed 90ºC.
Dimensions
Fixinf Base
Model
Width
L
(mm)
Height
H
(mm)
Depth
P
(mm)
A
(mm)
B
(mm)
C
(mm)
D
(mm)
Mounting
Screw
Weight
[Kg]
Degree of
Protection
1.6A/200-240V 100 132
82
90 120
5
6
M4
0.7
IP20
2.6A/200-240V 100 132
82
90 120
5
6
M4
0.7
IP20
4.0A/ 200-240V
100
132
82
90
120
5
6
M4
0.7
IP20
7.3A/200-240V 120 161
82
110 149
5
6
M4
1.0
IP20
10.0A/200-240V 120 191
82
110 179
5
6
M4
1.2
IP20
1.6/110-127V 100 132 82 90 120 5
6
M4
0.7
IP20
2.6/110-127V 100 132 82 90 120 5
6
M4
0.7
IP20
4.0/110-127V 100 161 83 110 149 5
6
M4
1.0
IP20
