background image

                                                                                                                   

SHANGHAI EUCHIPS INDUSTRIAL CO.,LTD

 

EUP12R-1WMC-0    User Manual V01.1   

                                                          1                                                                       

www.euchips.com 

 

 

EUP12R-1WMC-0 

2.4G Constant Current Dimming Driver 

 

Summary 

 

EUP12R-1WMC-0 is a constant current mode output LED driver. The output current can be easily set via the DIP dial 

switch. This driver could be controlled by the 2.4G remote RC14 or RC11 to dim lightings. Each driver could at the 

same time be matched and controlled by 10 remotes, and one remote can match unlimited drivers. 

Product Features 

 

Single channel output, output current level selectable by DIP S.W 

 

Using 2.4GHz RF remote control 

 

Wide range of input voltage 100VAC ~ 240VAC 

 

High efficiency up to 82% 

 

Built-in active PFC function 

 

Dimming effect smooth, no flicker 

 

Protections: Short circuit. 

 

Suitable for indoor LED lighting application, such as down light, panel light, and so on 

Summary of Contents for EUP12R-1WMC-0

Page 1: ... remote RC14 or RC11 to dim lightings Each driver could at the same time be matched and controlled by 10 remotes and one remote can match unlimited drivers Product Features Single channel output output current level selectable by DIP S W Using 2 4GHz RF remote control Wide range of input voltage 100VAC 240VAC High efficiency up to 82 Built in active PFC function Dimming effect smooth no flicker Pr...

Page 2: ...ncy 82 230VAC full load Current 0 1Amax 230VAC Inrush current 15A 230VAC Protection Short circuit Close output recovers automatically after fault removed Function Dimming 2 4GHz RF remote control Optional remote control RC14 RC11 Others Dimension 150 43 29 mm L W H G W 120g Working temp 20 40 Relative humidity 20 90 RH Dimension mm Current Selection Table EUP12R 1WMC 0 is a multi current dimming d...

Page 3: ...lease ensure good ventilation 4 Please check if the output voltage and current of any LED power supplies used comply with the requirement of the product 5 Please ensure that adequate sized cable is used from the controller to the LED lights to carry the current Please also ensure that the cable is secured tightly in the connector 6 Ensure all wire connections and polarities are correct before appl...

Page 4: ... want to make a little adjustment upon your fond then you may want to change the previous groups Before regrouping you need to clear the code the method is as following Full clear code Choose the led driver you want to clear the code If more than one driver needs to be clear the operation is performed at the same time turn off the power for 10 seconds then turn on the power again Within 3 seconds ...

Reviews: