![background image](http://html1.mh-extra.com/html/abb/acs880-x04/acs880-x04_firmware-manual_3389539497.webp)
Fault tracing 497
8
Fault tracing
What this chapter contains
The chapter lists the warning and fault messages including possible causes and
corrective actions. The causes of most warnings and faults can be identified and
corrected using the information in this chapter. If not, an ABB service representative
should be contacted.
Warnings and faults are listed below in separate tables. Each table is sorted by
warning/fault code.
Safety
WARNING!
Only qualified electricians are allowed to service the drive. Read
the
Safety instructions
on the first pages of the Hardware manual before
working on the drive.
Indications
Warnings and faults
Warnings and faults indicate an abnormal drive status. The codes and names of
active warnings/faults are displayed on the control panel of the drive as well as the
Drive composer PC tool. Only the codes of warnings/faults are available over
fieldbus.
Warnings do not need to be reset; they stop showing when the cause of the warning
ceases. Warnings do not latch and the drive will continue to operate the motor.
Faults do latch inside the drive and cause the drive to trip, and the motor stops. After
the cause of a fault has been removed, the fault can be reset from a selectable
Содержание ACS880-x04
