![background image](http://html1.mh-extra.com/html/abb/acs880-x04/acs880-x04_firmware-manual_3389539328.webp)
328 Parameters
Selects the fault limit for the brake resistor protection based
on the thermal model. See parameter
.
When the limit is exceeded, the drive trips on fault
The value is given in percent of the temperature the resistor
reaches when loaded with the power defined by parameter
105%
0 … 150%
Brake resistor temperature fault limit.
1 = 1%
Selects the warning limit for the brake resistor protection
based on the thermal model. See parameter
When the limit is exceeded, the drive
generates a
warning.
The value is given in percent of the temperature the resistor
reaches when loaded with the power defined by parameter
95%
0 … 150%
Brake resistor temperature warning limit.
1 = 1%
44
Configuration of mechanical brake control.
See also section
(page
Displays the mechanical brake control status word.
This parameter is read-only.
-
0000h…FFFFh
Mechanical brake control status word.
1 = 1
Displays the torque (in percent) at the instant of the previous
brake close command.
This value can be used as a reference for the brake open
torque. See parameters
.
A filtering time for this value can be defined using
-
-1600.0 … 1600.0% Torque at brake closure.
See par.
No.
Name/Value
Description
Def
/
FbEq16
Bit
Name
Information
0
Open command
Close/open command to brake actuator (0 = close, 1 = open).
Connect this bit to desired output.
1
Opening torque
request
1 = Opening torque requested from drive logic
2
Hold stopped
request
1 = Hold requested from drive logic
3
Ramp to stopped
1 = Ramping down to zero speed requested from drive logic
4
Enabled
1 = Brake control is enabled
5
Closed
state
6
Opening
state
7
Open
state
8
Closing
state
9…15
Reserved
Содержание ACS880-x04
