![background image](http://html1.mh-extra.com/html/abb/acs880-x04/acs880-x04_firmware-manual_3389539267.webp)
Parameters 267
Defines a minimum torque limit for the drive (in percent of
nominal motor torque). See diagram at parameter
.
The limit is effective when
• the source selected by
is 0, or
•
is set to
Note:
Do not set this parameter to 0% in an attempt to prevent
reverse rotation. In an open-loop application, that is likely to
prevent the motor from stopping altogether. To prevent
reverse rotation, use the speed/frequency limits in this
parameter group, or parameters
.
-300.0%
-1600.0 … 0.0%
Minimum torque limit 1.
See par.
Defines a maximum torque limit for the drive (in percent of
nominal motor torque). See diagram at parameter
.
The limit is effective when
• the source selected by
is 0, or
•
is set to
300.0%
0.0 … 1600.0%
Maximum torque 1.
See par.
Defines the source of the minimum torque limit for the drive (in
percent of nominal motor torque) when
• the source selected by parameter
is 1, or
•
is set to
.
See diagram at
Note:
Any positive values received from the selected source
are inverted.
Zero
None.
0
AI1 scaled
(see page
).
1
AI2 scaled
(see page
).
2
PID
(output of the process PID
controller).
5
Minimum torque 2
6
Source selection (see
). -
Defines the source of the maximum torque limit for the drive
(in percent of nominal motor torque) when
• the source selected by parameter
is 1, or
•
is set to
.
See diagram at
Note:
Any negative values received from the selected source
are inverted.
Zero
None.
0
AI1 scaled
(see page
).
1
AI2 scaled
(see page
).
2
PID
(output of the process PID
controller).
5
Maximum torque 2
6
Source selection (see
). -
No.
Name/Value
Description
Def
/
FbEq16
Содержание ACS880-x04
