ABB ACS880-x04, Руководство по прошивке

Страница: 133 / 604

Parameters 133
06.17 Drive status word 2 Drive status word 2.
This parameter is read-only. -
0000h…FFFFh Drive status word 2. 1 = 1
No. Name/Value Description Def / FbEq16
Bit Name Description
0 Identification run done 1 = Motor identification (ID) run has been performed
1 Magnetized 1 = The motor has been magnetized
2 Torque control 1 = Torque control mode active
3 Speed control 1 = Speed control mode active
4 Power control Reserved.
5 Safe reference active 1 = A “safe” reference is being applied by functions such as
parameters 49.05 and 50.02
6 Last speed active 1 = A “last speed” reference is being applied by functions such
as parameters
49.05 and 50.02
7 Loss of reference 1 = Reference signal lost
8 Emergency stop failed 1 = Emergency stop failed (see parameters 31.32 and 31.33 )
9 Jogging active 1 = Jogging enable signal is on
10 Above limit 1 = Actual speed, frequency or torque equals or exceeds limit
(defined by parameters
46.31 … 46.33 ). Valid in both directions of
rotation.
11 Emergency stop active 1 = An emergency stop command signal is active, or the drive is
stopping after receiving an emergency stop command.
12 Reduced run 1 = Reduced run active (see section Reduced run function on
page 93 )
13 Reserved
14 Stop failed 1 = Stopping failed (see parameters 31.37 and 31.38 )
15 Reserved