ABB ACS880-x04, Руководство по прошивке

Страница: 334 / 604

334 Parameters
45.09 CO2 reduction in
tons Displays the reduction in CO
2
emissions in metric tons
compared to direct-on-line motor connection. This value is
calculated by multiplying the saved energy in MWh by the
value of parameter
45.18 CO2 conversion factor (by default,
0.5 metric tons/MWh).
When this parameter rolls over, parameter
45.08 CO2
reduction in kilotons is incremented.
This parameter is read-only (see parameter 45.21 Energy
calculations reset ).
-
0.0 … 999.9 metric
tons Reduction in CO
2
emissions in metric tons. 1 = 1 metric
ton
45.11 Energy optimizer Enables/disables the energy optimization function. The
function optimizes the motor flux so that total energy
consumption and motor noise level are reduced when the
drive operates below the nominal load. The total efficiency
(motor and drive) can be improved by 1…20% depending on
load torque and speed.
Note: With a permanent magnet motor or a synchronous
reluctance motor, energy optimization is always enabled
regardless of this parameter.
Disable
Disable Energy optimization disabled. 0
Enable Energy optimization enabled. 1
45.12 Energy tariff 1 Defines energy tariff 1 (price of energy per kWh). Depending
on the setting of parameter
45.14 Tariff selection , either this
value or 45.13 Energy tariff 2 is used for reference when
monetary savings are calculated.
The currency is defined by parameter
45.17 Tariff currency
unit .
Note: Tariffs are read only at the instant of selection, and are
not applied retroactively.
1.000 units
0.000 …
4294967.295 units Energy tariff 1. -
45.13 Energy tariff 2 Defines energy tariff 2 (price of energy per kWh).
See parameter
45.12 Energy tariff 1 .
2.000 units
0.000 …
4294967.295 units Energy tariff 2. -
45.14 Tariff selection Selects (or defines a source that selects) which pre-defined
energy tariff is used.
0 =
45.12 Energy tariff 1
1 = 45.13 Energy tariff 2
Energy tariff
1
Energy tariff 1 0. 0
Energy tariff 2 1. 1
DI1 Digital input DI1 ( 10.02 DI delayed status , bit 0). 2
DI2 Digital input DI2 ( 10.02 DI delayed status , bit 1). 3
DI3 Digital input DI3 ( 10.02 DI delayed status , bit 2). 4
DI4 Digital input DI4 ( 10.02 DI delayed status , bit 3). 5
DI5 Digital input DI5 ( 10.02 DI delayed status , bit 4). 6
DI6 Digital input DI6 ( 10.02 DI delayed status , bit 5). 7
DIO1 Digital input/output DIO1 ( 11.02 DIO delayed status , bit 0). 10
DIO2 Digital input/output DIO2 ( 11.02 DIO delayed status , bit 1). 11
No. Name/Value Description Def / FbEq16