![background image](http://html1.mh-extra.com/html/abb/acs880-x04/acs880-x04_firmware-manual_3389539399.webp)
Parameters 399
Displays the temperature measured through the sensor input
of interface module 2. The unit is selected by parameter
.
Note:
With a PTC sensor, the unit is ohms.
This parameter is read-only.
-
0…1000 °C, °F or
ohm
Temperature measured through interface module 2.
-
Validates any changed encoder interface module parameters.
This is needed for any parameter changes in groups 90…93
to take effect.
After refreshing, the value reverts automatically to
.
Notes:
• Permanent magnet motors only: The drive will perform a
fresh autophasing routine (see page
) at next start if the
motor feedback encoder settings have been changed.
• The parameter cannot be changed while the drive is
running.
Done
Refreshing done.
0
Refresh
Refreshing.
1
Defines the type of the module used as interface module 1.
None
None (communication disabled).
0
FEN-01
FEN-01.
1
FEN-11
FEN-11.
2
FEN-21
FEN-21.
3
FEN-31
FEN-31.
4
FSE-31
FSE-31.
5
Specifies the slot (1…3) on the control unit of the drive into
which the interface module is installed. Alternatively, specifies
the node ID of the slot on an FEA-03 extension adapter.
Slot 1
Slot 1.
1
Slot 2
Slot 2.
2
Slot 3
Slot 3.
3
4…254
Node ID of the slot on the FEA-03 extension adapter.
1 = 1
Defines the type of the module used as interface module 2.
None
None (communication disabled).
0
FEN-01
FEN-01.
1
FEN-11
FEN-11.
2
FEN-21
FEN-21.
3
FEN-31
FEN-31.
4
FSE-31
FSE-31.
5
Specifies the slot (1…3) on the control unit of the drive into
which the interface module is installed. Alternatively, specifies
the node ID of the slot on an FEA-03 extension adapter.
Slot 1
Slot 1.
1
Slot 2
Slot 2.
2
Slot 3
Slot 3.
3
4…254
Node ID of the slot on the FEA-03 extension adapter.
1 = 1
No.
Name/Value
Description
Def
/
FbEq16
Содержание ACS880-x04
