www.DanaherMotion.com
OC950 EPROM Installation Instructions
For OC950-600-UP & OC950-500-UP
NOTE
Remove AC Input Power from the controller before disassembly.
OC950 EPROM Installation
Requirements
1. Perform this operation on a dry surface with a clear area of at least 12 in wide and 12 in
deep. The area should be static free, and precautions to safeguard the EPROMS
against static discharge should be taken.
2. A PLCC extraction tool is required for removing the EPROMS. It is included in upgrade
kit.
Manufacturer
Part Number
McKenzie
TOL PL CC-XT-2
Procedure
1. Prepare the static free worktable.
2. Remove power from the drive.
3. Remove the option card from the drive.
4. Place the option card on the edge of the table with the faceplate facing toward you and
overhanging the edge. Connector J51 should be on the left side of the faceplate.
NOTE
Be careful not to stress or bend the PC board.
NOTE
Pin 1 on the EPROM is indicated by a dot and is silk-screened on
the PC Board. The EPROM is also keyed on one corner.
