Strasbaugh 6DS-SP, Operation Manual

Page: 620 / 1562

Maintenance Model 6DS-SP Planarizer
9 - 112 Version 4.0 - February 1998
6. a. Turn the machine power to ON by pressing the green <MACHINE
ON> button located on the control panel.
b. Perform the home sequence routine.
7. At Page 1 of the Manual Control Menu select Bridge Move and choose
Pol tbl 1 to move the bridge to its polish position.
8. Reattach the clamp and the dial indicator.
9. At Page 2 of the Manual Control Menu, select Right Spindle Up/Down
and choose Down to lower the right spindle.
10. Readjust the dial indicator for a 5-in. radius.
11. Select Right Spindle Speed and enter 2 to rotate the spindle at
approximately 2 RPM.
12. Read the indicator dial as the spindle rotates.
13. Adjust the four top set screws in the spindle collar:
a. With the indicator rotated to the front of the machine, turn the dial
to
0 .
b. As the spindle rotates, read the dial for the farthest reading from
zero.
Note the reading and its location.
c. Select Right Spindle Speed and enter 0 to stop the spindle.
d. Tighten the two top set screws corresponding to the location of the
reading farthest from 0. For each screw:
Using a 3/16-in. hex key, tighten 1/8 turn clockwise.
e. Select Right Spindle Speed and enter 2 to restart the spindle.
f. Re-zero the dial indicator.
g. Reread the dial indicator:
If the readings continue to vary more than +/- .001 in., adjust the 4
side set screws as discussed in the step immediately below.