SCM Olimpic K 1000, Instruction Manual

Page: 548 / 583

9
9.4
USE AND OPERATION
EN
INSTRUCTION MANUAL TRANSLATION OF THE ORIGINAL INSTRUCTIONS
2
9.2- 9.2- STOP MODES
9.2.1- 9.2.1- NORMAL STOP
Proceed as follows:
• Make sure that there are no panels in the machine.
• Press the STOP button
(FIG.2-REF.1 or FIG.3-REF.1) .
This stops the enabled motors and interrupts the machining cycle.
• Wait until the unit motors are fully stopped.
USE THIS METHOD OF STOPPING THE MACHINE WHEN THERE ARE NO PANELS TO
BE MACHINED, AT THE END OF A WORK CYCLE, ETC., I.E. IN ALL PHASES OF NORMAL
PRODUCTION. DO NOT USE THIS METHOD OF STOPPING THE MACHINE IN DANGEROUS
CONDITIONS.
NOTHING HAPPENS IF THE STOP BUTTON (FIG.2-REF.1 or FIG.3-REF.1) IS PRESSED
DURING THE WORK CYCLE WITH PANELS IN THE MACHINE.