SCM Olimpic K 1000, Instruction Manual

Page: 404 / 583

INSTRUCTIONS FOR USE AND MAINTENANCE
RIP.34
EN
30
RIP/6.3- RIP/6.3- TOOLS REPLACEMENT TOOLS REPLACEMENT
OBSERVE THE INDICATIONS GIVEN IN PAR.5.2.
WHENEVER POSSIBLE WAIT UNTIL ALL PARTS WHICH HAVE BECOME HOT DURING
MACHINING, COOL DOWN BEFORE TOUCHING THEM (30 min IS LONG ENOUGH), TO
AVOID GETTING BURNT.
Proceed as follows:
Lower motor (FIG.30-REF.1) :
• Remove the electric connector from the terminal board (FIG.30-REF.2) .
• Loosen the release handle (FIG.30-REF.3).
• Move the motor back and slide it out (v. FIG.30) .
• Place the motor on the work bench
• Unscrew the nut (FIG.31-REF.1) while holding the motor.
• Replace the tool (FIG.31-REF.2) .
BE CAREFUL TO THE ROTATION DIRECTION: THE CUTTING EDGES OF THE TOOLS MUST
WORK AGAINST PANEL ADVANCEMENT (FIG.32).
• Replace the motor.
CHECK THAT THE COUPLING AND CONTROL SURFACES OF THE MOTOR ARE PERFECTLY
CLEAN.
• Block the release handle (FIG.30-REF.3) .
• Connect the electric connector.
Upper motor: proceed as for the upper track feeler.