Ross Synergy 100 MD, Operator'S Manual

Page: 301 / 402

Synergy 100 MD Operator’s Manual (v7.2 MD-S100) Squeeze & Tease MD Sequences and Wipes • 17–25
Running a Sequence with a Hold
A Hold inserted in a sequence requires manual input to continue when the sequence is being run.
Use the following procedure to run a sequence with a Hold:
1. Load a sequence. Refer to the section “ Loading a Sequence ” on page 17–20 for details.
2. Run the sequence using
AUTO TRANS
. Refer to the section “ Running a Sequence ”
on page 17–23 for details.
When you run the sequence, it will stop when it reaches the point where the
Hold
was
inserted.
3. Press the flashing
AUTO TRANS
button to continue running the sequence.
The sequence will continue as saved.
This completes the procedure to run a sequence with a Hold.