Ross Synergy 100 MD, Operator'S Manual

Page: 164 / 402

9–10 • Memory and Disk Functions Synergy 100 MD Operator’s Manual (v7.2 MD-S100)
5. To perform the Effects Dissolve , press
CNTR
(
EFF D
) and recall the second setup from
memory. The system first recalls all non-dissolving values (with a cut) and then slews all
analog values.
Location and Rotation Effects Dissolve
6. Repeat step 6 if you want to slew back to the first setup or to any additional registers that
have been properly stored in preparation for the Effects Dissolve function. You can slew
or cut between as many setups as desired, simply governed by the
CNTR
(
EFF D
)
button and the way that the effect was programmed.
This completes the procedure for perform a basic effects dissolve.
Working with Channels and Objects
The following table can be used to predict how the Effects Dissolve will behave when working with
various combinations of channels and objects.
Operating
Tip
Pressing another memory button while an effects dissolve is in
progress will cause the dissolve to stop and transition from its current
state (midway between the original two memories) to the state of the
destination effect.
The menu will not show the image moving or changing while the
effects dissolve is in progress. It will be updated with the new values
once the dissolve is finished.
Important Channels will not interpolate across Keyers. You cannot perform an
Effects Dissolve from one Keyer to another.
Effects Dissolve Behavior Table
Scenario Result
The source effect has two channels and the
destination effect has two channels.
Channel 1 will interpolate to the
destination effect for Channel 1 .
Channel 2 will interpolate to the
destination effect for Channel 2 .
Note: This will occur no matter what video
sources are assigned to
Channels 1 and 2 .
Source Effect
Destination Effect