Ross Synergy 100 MD, Operator'S Manual

Page: 150 / 402

8–2 • Key Modifiers Synergy 100 MD Operator’s Manual (v7.2 MD-S100)
Filling a Key with Matte
Use the following procedure to fill a key with matte color in Key 1:
1. Select a background source on the PGM bus. This provides the background over which
the key will appear.
2. Press KEY1 in the Transition Control Group to preview the key. This step will also
serve to assign the Key bus and Effects Keyers Group to Key 1 .
3. Select a key source on the Key 1 bus.
4. Select either SELF KEY , AUTO SELECT , or CHROMA KEY in the Effects Keyers
Group .
5. Press MATTE FILL in the Effects Keyers Group . The key fill will now be replaced
with the current color from the matte generator.
6. Adjust the color of the matte as follows:
• HUE — Use the HUE knob in the Mattes Group to adjust the color of the matte
generator.
• SAT — Use the SAT knob in the Mattes Group to adjust the color saturation. The
saturation can be adjusted from monochrome, or no saturation, to full color
saturation.
• LUM — Use the LUM knob in the Mattes Group to adjust the luminance of the
color. The luminance can be adjusted from minimum brightness to maximum
brightness.
7. Add additional key modifiers as required.
8. Perform a CUT , AUTO TRANS , or move the fader from one limit to the other to take
your key on-air.
This completes the procedure for filling a key with matte color in Key 1. Refer to the section “ Mattes
Group ” on page 6–10 for more detailed color instructions.
Note
You cannot apply
MATTE FILL
to a
PST PATT
key. Matte Fill can
be applied to all other key types.