Ross Synergy 100 MD, Operator'S Manual

Page: 74 / 402

4–12 • Switcher Basics Synergy 100 MD Operator’s Manual (v7.2 MD-S100)
will be lit
Red
to indicate that the crosspoint is contributing to the main program output. For example,
if you select Key 1 for your next transition by pressing the
KEY1
button in the Transition Control
Group , the Key bus will be assigned to Key 1 and the lit crosspoint will be taken on-air with the next
transition. If you perform a transition, you will see the crosspoint button change color from
White
to
Red
, indicating that it is now on-air.
Knobs
There are ten rotary, end-stop, knobs on the Synergy 100 MD control panel that allow you to adjust
various values.
Mattes Group — End-Stop Knobs
Each of these knobs has an upper and lower limit that it cannot be turned past. When using the knobs,
it may be necessary to re-synchronize the knob position with the electronic values you are adjusting.
Operating
Tip
To re-synchronize an End-stop Knob , turn the knob fully clockwise,
then fully counter-clockwise. Full-range adjustments can now be
made.
HUE
SAT
LUM
M A T T E S
E n d S t o p
K n o b s