Ross Synergy 100 MD, Operator'S Manual

Page: 89 / 402

Synergy 100 MD Operator’s Manual (v7.2 MD-S100) Transitions • 5–9
• You can not initiate an Auto Transition or a Cut in the Transition Control group if the
Fader is off its upper or lower limit.
Changing Auto Transition Rates
The rate at which an Auto Transition is run is set from the System Control Group . This value is in
video frames and varies in time according to the video format you are using. If you are operating at
60 Hz, a single video frame is 1/30th of a second, whereas, at 50 Hz, a single video frame is 1/25th of
a second. If you are using film, a video frame is 1/24th of a second.
Note that Transition Rates for MultiDSKs can only be set through the menu system. Refer to the
section “
Setting MultiDSK Sources and Transition Rates ” on page 7–35 for more information.
Use the following procedure to set the Auto Transition Rate:
1. Press the right
SEL
button repeatedly until
AUTO
is displayed in the Mode area. If you
want to adjust the Fade to Black rate, you would display
FADE
in the Mode area, and
for DSK Dissolve you would display
DSK
. The rest of the procedure is the same.
System Control Group
2. Use the 100 , 10 and 1 buttons to enter the desired Auto Transition rate, in frames,
between 1 and 999 . The new rate is automatically updated and appears in the display.
System Control Group
This completes the procedure for setting the Auto Transition Rate. The switcher will use this rate for
the next Auto Transition that is run.
Note If the Trans Limit function was active during the transition, the
switcher will treat the point that the transition was stopped at as the
Trans Limit for that particular transition.
Note There is no way to cancel or undo your changes. If you do not want to
keep your changes, you will have to follow the procedure to set the
original rate again.
Operating
Tip
If you press and hold one of the buttons, that value will reset back to
the beginning.
S Y S T E M C O N T R O L
EDIT
SEL BACK MENU
100 10 1
AUTO
1 2 0
S Y S T E M C O N T R O L
EDIT
SEL BACK MENU
100 10 1
AUTO
1 5 0