Ross Synergy 100 MD, Operator'S Manual

Page: 176 / 402

10–6 • Peripheral Control and More Synergy 100 MD Operator’s Manual (v7.2 MD-S100)
Operating a Remote Aux Panel
Before attempting to use your Assignable Remote Aux Panel, ensure that it is properly connected to
the Synergy 100 MD switcher.
Use the following procedure to operate a Remote Aux Panel in Regular Mode :
1. Ensure that the Aux Bus that is being controlled by the Remote Aux Panel is routed to
the desired location or device.
2. Press
Assign 1
through
Assign 10
to assign the Remote Aux Panel to the
corresponding Aux Bus. Refer to the following table to determine which Aux Bank and
Bus is mapped to each button.
Remote Aux Panel — ASSIGN Buttons
3. Select the signal that you want to feed to the Aux Bus output BNC by using one of the
following options:
• Press a crosspoint button to route the associated video signal to the Aux Bus output
BNC.
~
If the panel is configured to use shifted crosspoints, hold down the
SHIFT
button on the Remote Aux Panel, then press the desired crosspoint to select the
shifted video signal.
~ Panels that are not configured to use shifted crosspoints assign the
SHIFT
button as the last of the regular crosspoints.
• Selecting
BKGD Color
(Shifted button 1) on a Remote Aux Panel routes the
Program output to the Aux Bus.
• Press
CLN FEED
to route the Clean Feed output to the Aux Bus.
• Press
PGM
to route the Program output to the Aux Bus.
This completes the procedure to operate a Remote Aux Panel in Regular Mode .
Note If the Remote Aux Panel is in Follow Mode , you will not be able to
change the output assigned from the control panel. You will be able to
view different Aux Buses; however, you will not be able to alter the
output.
Note
The special crosspoints, such as PV and CLN FEED , do not support
the shifted function.
BLACK SHIFT
MLE
PV
CLN
FEED
PGM PV
ASSIGN
1
ASSIGN
2
ASSIGN
3
ASSIGN
4
ASSIGN
5
ASSIGN
6
ASSIGN
7
ASSIGN
8
ASSIGN
9
ASSIGN
10
Aux 0
Aux 1
Aux 2
Aux 3
Aux 8
Aux 9
Aux 4
Aux 5
Aux 6
Aux 7