Ross Synergy 100 MD, Operator'S Manual

Page: 346 / 402

19–22
•
WARP Effects Synergy 100 MD Operator’s Manual (v7.2 MD-S100)
Page Roll
This WARP has the following parameters that can be adjusted.
•
Position
— This parameter adjusts the fold of the page turn.
•
Light
— This parameter adjusts the on-board lighting.
WARP Menu — Page Roll
Position Parameters
The Position parameters are accessed by pressing 5. Position on the Page Roll WARP Menu .
Page Roll WARP Menu — Position Parameters
• Use the
HUE
knob to adjust the roll of the page turn on the image.
• Use the
SAT
knob to adjust the radius of the fold. This indicates whether the fold is wide
or narrow.
• Use the LUM knob to adjust the angle or axis of the fold. This specifies the corner at
which the fold begins.
Operating
Tip
The Page Roll WARP can be used in wipes or other effects.
Important When working with Page Roll, keep in mind that the parameters are
applied based on the whole screen area (as if the image were full
screen). This means that if you change the page turn parameters, then
move the image along the Z-Axis (so it appears smaller) you will not
see any part of the effect that is happening where there is no key video.
Active Warp: Page Roll
Warp Key 1
0. Category Favorites
1. Warp List
5. Position
6. Light
Page Roll
Use positioner or Hue, Sat, Lum to modify
Warp Key 1
0. Category Favorites
1. Warp List
5. Position
6. Light
Page Roll
Position:
Roll:
0.0%
Radius: 20.2%
Angle: 0.125