Ross Synergy 100 MD, Operator'S Manual

Page: 299 / 402

Synergy 100 MD Operator’s Manual (v7.2 MD-S100) Squeeze & Tease MD Sequences and Wipes • 17–23
Running a Sequence
The System Control Group indicates the programmed sequence rate in frames. If the sequence has
been manually set to run at a different rate, the text on the Display in the System Control Group
alternates between AUTS and OVER .
Running a Sequence
Remember, the sequence rate determines how fast the sequence will run on the switcher. When you
create the sequence, you establish its duration. This rate is the default sequence rate. If you want the
sequence to run at a different rate, you can set a new rate manually.
Running a Sequence at the Default Rate
Use the following procedure to run the sequence at the default sequence rate:
1. Ensure the sequence is loaded. Refer to the section “ Loading a Sequence ” on
page 17–20 for instructions.
2. Press the DISS , WIPE and DVE SEND buttons at the same time.
Operating
Tip
Double-pressing the
DISS
,
WIPE
and
DVE SEND
buttons at the
same time displays a list of sequences for quick access via the Pattern
Control Group . Refer to the section “ Programming Pattern Control
Buttons ” on page 17–26 for more information.
Note
When attempting to run a sequence on a background rather than a key,
it will automatically run as a dissolve.
You cannot select PST Black or Trans PV with sequence mode.
Operating
Tip
You can also press SEL/DVE and R
UN
F
WD
or SEL/DVE and R
UN
R
EV
. You must have a Fly-Key selected as the next transition.
Keep in mind when the sequence runs in reverse, it snaps to the last
keyframe in the sequence.
ON AIR ON AIR ON AIR ON AIR
ON AIR
BKGD KEY1 KEY2
DISS
CUT
WIPE
AUTO
TRANS
TRANS
LIMIT
DSK
CUT
PST
BLACK
DSK
DISS
FADE
TO
BLACK
DVE
T R A N S I T I O N C O N T R O L
Use this button to
cut a key on or off
Press DISS , WIPE , DVE
to prepare to run the sequence
Use this button to run the
sequence automatically
Use the fader to run
the sequence manually