Ross Synergy 100 MD, Operator'S Manual

Page: 379 / 402

Synergy 100 MD Operator’s Manual (v7.2 MD-S100) Appendix C. Hotkeys
•
22–3
Using Hotkeys
Hotkeys are activated by pressing and holding the middle SEL button and then pressing the
crosspoint button corresponding to the hotkey you want to activate. The Hotkey functionality is only
available for Flying Keys.
Using Hotkeys
Use the following procedure to use a hotkey on the Synergy 100 control panel:
1. Ensure that you are flying a key.
2. Press and hold the middle
SEL
button, in the Mattes section of the Menu Control
Group .
Synergy 100 Control Panel — Middle SEL Button
3. Press the crosspoint button that corresponds to the hotkey you want to activate. Refer to
the section “ Hotkey Functions ” on page 22–4 for a list of the available hotkey functions
on the Synergy 100 control panel.
4. Release the middle SEL button. Once you have activated the hotkey, you no longer need
to hold down the SEL button.
5. Edit the channel as needed and exit the menu as you would normally.
This completes the procedure for activating a hotkey.
Operating
Tip
You can latch the middle
SEL
in hotkey mode by double-pressing it.
Double-pressing it again will take it out of hotkey mode.
B
USY
E F F E C T S C O N T R O L M A T T E S S Y S T E M C O N T R O L
EDIT
SEL BACK MENU SEL CNTR
DVE
ON AIR
KEY1
KEY2
DSK
PGM
PST
ON AIR ON AIR ON AIR ON AIR
ON AIR
ASPECT
HUE/
TRANSP
GAIN
CLIP
HUE
SAT
LUM CLIP GAIN SOFT BORDER
SEL
REV
MEM
FLY
KEY
SELF
KEY
BLACK SHIFT
SHIFT
SHIFT
BLACK
BLACK
AUTO
SELECT
MASK
KEY
INVERT
PST
PATT
CHROMA
KEY
MATTE
FILL
KEY2
KEY
MEM
MATTE
FILL
SELF
KEY
AUTO
SELECT
MASK
BKGD KEY1 KEY2
DISS
CUT
WIPE
AUTO
TRANS
TRANS
LIMIT
DSK
CUT
PST
BLACK
DSK
DISS
FADE
TO
BLACK
DVE
KEY
INVERT
CHAR
GEN1
CHAR
GEN2
DSK
PV
SHDW BORD OUTL ROTATE
ASPECT
5
0
6
1
7
2
8
3
9
100 10 1 4
D O W N S T R E A M K E Y E R
T R A N S I T I O N C O N T R O L
M A T T E S E F F E C T S K E Y E R S E F F E C T S C O N T R O L