Ross Synergy 100 MD, Operator'S Manual

Page: 302 / 402

17–26 • Squeeze & Tease MD Sequences and Wipes Synergy 100 MD Operator’s Manual (v7.2 MD-S100)
Using the Pattern Control Buttons
Pattern Buttons 8 and 9 are sometimes used by the system when loading a sequence using the menus.
Keep this in mind when assigning sequences to these Pattern Buttons , as they may be overwritten.
• If you load a sequence in Key 1, the system checks whether there is a pattern button
associated with that sequence. If no button is associated with the sequence, the system
will use
Pattern Button 8 (overwriting the program previously assigned to that button).
• If you load a sequence in Key 2, the system checks whether there is a pattern button
associated with that sequence. If no button is associated with the sequence, the system
will use
Pattern Button 9 (overwriting the program previously assigned to that button).
• If you press WIPE with the key flown, double-pressing the assigned pattern button will
assign the sequence to a wipe. Pressing the AUTO TRANS button will then run the
wipe. Moving the fader handle runs the wipe at a speed controlled by the fader
movement.
Programming Pattern Control Buttons
The sequences you create and save can be mapped to buttons in the Pattern Control Group .
Use the following procedure to map a sequence to a Pattern Control button:
1. Ensure the sequence is loaded. Refer to the section “ Loading a Sequence ” on
page 17–20 for instructions.
2. Press the
DISS
,
WIPE
and
DVE SEND
buttons at the same time.
3. Double-press the Pattern Button you want to program.
4. Using the
ª
and
©
buttons in the System Control Group , scroll to the desired
sequence number.
5. Press
SEL
in the System Control Group to save the assignment.
This completes the procedure to program pattern buttons.