Ross Synergy 100 MD, Operator'S Manual

Page: 92 / 402

5–12 • Transitions Synergy 100 MD Operator’s Manual (v7.2 MD-S100)
4. In the Transition Type Section , press
DISS
.
5. To perform a manual transition, move the Fader from limit to limit. To perform an auto
transition, press the
AUTO TRANS
button. During either transition, the PST bus video
signal gradually mixes into the PGM signal, as shown below.
Sample Setup – Performing a Transition
At the end of the transition, the PST video completely replaces the PGM video and the
buses flip-flop. The figure below illustrates the MLE and monitor setup after the
dissolve.
Sample Setup – After the Dissolve
This completes the procedure for performing a dissolve.
Performing a Transition Limit Effect
The TRANS LIMIT button in the Transition Control Group allows you to stop a transition at a
position in between the two absolute Fader limits.
Use the following procedure to perform a transition limit effect:
1. Ensure the Fader is at an upper or lower limit and note the limit that you choose. The
Fader must be returned to this limit in a subsequent step.
Note
If a very short auto transition rate is selected (typically five frames or
less), this may appear the same as a cut. This type of transition is often
called a “soft cut”.
Note
If you have the MultiDSK option installed, refer to the section
“
MultiDSK Operation ” on page 7–35 for information on performing
transitions.
KEY1
KEY2
DSK
PGM
PST
BLACK
BLACK
CAM
1
VTR
1
VTR
2
VTR
3
CAM
2
CAM
1
VTR
1
VTR
2
VTR
3
CAM
2
CAM
1
VTR
1
VTR
2
VTR
3
CAM
2
BLACK
Preview Monitor
(CAM 2)
Program Monitor
(VTR 1)
KEY1
KEY2
DSK
PGM
PST
BLACK
BLACK
CAM
1
VTR
1
VTR
2
VTR
3
CAM
2
CAM
1
VTR
1
VTR
2
VTR
3
CAM
2
CAM
1
VTR
1
VTR
2
VTR
3
CAM
2
BLACK
Preview Monitor
(CAM 2)
Program Monitor
(VTR 1)