Ross Synergy 100 MD, Operator'S Manual

Page: 104 / 402

6–10 • Pattern and Effects Control Synergy 100 MD Operator’s Manual (v7.2 MD-S100)
Mattes Group
The Mattes Groups provides a set of assignable controls that allow you to select specific matte
generators and adjust colors for wipe patterns, borders, the color background, and matte fills. The
Mattes Group is assigned to a specific function by pressing a PST PATT , WIPE , COLOR BKGD ,
BORD or MATTE FILL button.
The following figure illustrates the Mattes Groups :
Mattes Groups
1. Matte Color Knobs
The three Matte Color Knobs allow you to adjust the color of the selected matte
generator. Each knob is an “end-stop” knob. Refer to the section “ Knobs ” on page 4–12
for additional information on end-stop knobs.
• Rotate the
HUE
knob to change the color of the selected matte generator. A full 360
degrees of hue adjustment is provided.
• Rotate the
SAT
knob to change the color saturation of the selected matte generator.
Saturation can be adjusted from 0 (monochrome or no saturation) to 100 percent —
full color saturation.
1) Matte Color Knobs 2) Matte Destination Section
B
USY
E F F E C T S C O N T R O L M A T T E S S Y S T E M C O N T R O L
EDIT
SEL BACK MENU SEL CNTR
DVE
ON AIR
KEY1
KEY2
DSK
PGM
PST
ON AIR ON AIR ON AIR ON AIR
ON AIR
ASPECT
HUE/
TRANSP
GAIN
CLIP
HUE
SAT
LUM CLIP GAIN SOFT BORDER
SEL
REV
MEM
FLY
KEY
SELF
KEY
BLACK SHIFT
SHIFT
SHIFT
BLACK
BLACK
AUTO
SELECT
MASK
KEY
INVERT
PST
PATT
CHROMA
KEY
MATTE
FILL
KEY2
KEY
MEM
MATTE
FILL
SELF
KEY
AUTO
SELECT
MASK
BKGD KEY1 KEY2
DISS
CUT
WIPE
AUTO
TRANS
TRANS
LIMIT
DSK
CUT
PST
BLACK
DSK
DISS
FADE
TO
BLACK
DVE
KEY
INVERT
CHAR
GEN1
CHAR
GEN2
DSK
PV
SHDW BORD OUTL ROTATE
ASPECT
5
0
6
1
7
2
8
3
9
100 10 1 4
D O W N S T R E A M K E Y E R
T R A N S I T I O N C O N T R O L
M A T T E S E F F E C T S K E Y E R S E F F E C T S C O N T R O L
1 2
HUE
SAT