Raritan PX2-1000 SERIES, User Manual

Page: 47 / 648

Chapter 3: Installation and Configuration
28
Tip: You can type "
show network wireless
" to display a shortened
version of wireless settings.
11. If all are correct, type
exit
to log out of the PX. If any are incorrect,
repeat Steps 7 to 10 to change network settings.
The IP address configured may take seconds to take effect.
Bulk Configuration Methods
If you have to set up multiple PX devices, you can use one of the
following configuration methods to save your time.
Use a bulk configuration file:

Requirement: All PX devices to configure are of the same model and
firmware.

Procedure: First finish configuring one PX. Then save the bulk
configuration file from it and copy this file to all of the other PX
devices.
See
Bulk Configuration
(on page 294).
Use a TFTP server:

Requirement: DHCP is enabled in your network and a TFTP server
is available.

Procedure: Prepare special configuration files, which must include
fwupdate.cfg
, and copy them to the root directory of the TFTP server.
Re-boot all PX after connecting them to the network.
See
Bulk Configuration or Firmware Upgrade via DHCP/TFTP
(on
page 514).
Use a USB flash drive:

Requirement: A FAT32-formatted USB flash drive containing special
configuration files is required.

Procedure: Plug this USB drive into the PX. When a happy smiley is
shown on the front panel display, press and hold one of the control
buttons on the front panel until the display turns blank.
See
Configuration or Firmware Upgrade with a USB Drive
(on
page 503).