Qnergy PowerGen 5650 Series, Installation & Operation Manual

Page: 11 / 194

iii
Figure 12-5 Helium Fill Kit......................................................................................................... 77
Figure 12-6 Regulator Fitting, Inlet Nut, CGA 580..........................................................78
Figure 12-7 Helium Kit, Vent Valve.......................................................................................78
Figure 12-8 Helium Kit, Regulator Spring ..........................................................................79
Figure 12-9 Helium Tank.......................................................................................................... 80
Figure 12-10 Helium Kit, Purge.............................................................................................. 80
Figure 12-11 Helium Fill Rate.....................................................................................................81
Figure 12-12 Gas Pressure Reading......................................................................................83
Figure 12-13 Blower Tuning Screws.................................................................................... 84
Figure 12-14 Head Temp Setpoint ........................................................................................85
Figure 12-15 Lynx, Max Blower to 80%............................................................................. 86
Figure 12-16 Qnergy Lynx, QEC, Configuration Tab, Output Power
Limit............................................................................................................................ 86
Figure 12-17 FPC Tab, Enable...................................................................................................87
Figure 12-18 Qnergy Lynx, QEC, Configuration Tab, Minimum Engine
Power ........................................................................................................................ 88
Figure 12-19 Qnergy Lynx, Output Power Limit to 600W.......................................... 89
Figure 12-20 Blower Tuning Screws.....................................................................................91
Figure 12-21 Head Temp Setpoint..........................................................................................91
Figure 12-22 Qnergy Lynx, Max Blower to 80%.............................................................92
Figure 12-23 FPC Tab, Enable..................................................................................................93
Figure 12-24 Qnergy Lynx, QEC, Configuration Tab, Minimum Engine
Power .........................................................................................................................93
Figure 12-25 FEB GPIO Configuration ..................................................................................95
Figure 12-26 FEB Inputs, Outputs, and LD Disconnect Locations .......................... 98
Figure 12-27 Qnergy Lynx, QEC, Configuration Tab.....................................................108
Figure 12-28 Qnergy Lynx, QEC, Configuration Tab, Output Power
Limit...........................................................................................................................108
Figure 12-29 Qnergy Lynx, QEC, Load Following Setup Flow Chart .....................109
Figure 13-1 User Interface Controls ...................................................................................... 111
Figure 16-1 Battery Warning Label.....................................................................................140
Figure 16-2 PowerGen Left-Hand-Side Door Removed ...........................................140
Figure 16-3 PowerGen Left-Hand-Side View .................................................................141
Figure 17-1 Qnergy Lynx, Fill Sequence ............................................................................ 145
Figure 17-2 Radiator and Over Flow Tank.......................................................................146
Figure 17-3 Air Removal Plug ............................................................................................... 147
Figure 20-1 User Interface Indicators and Controls .................................................... 163
Figure 21-1 GHT Components................................................................................................ 167
Figure 21-2 LUI, with GHT Switch ........................................................................................168
Figure 21-3 Coolant Setpoints in Lynx ..............................................................................169
Figure 21-4 LTS Components.................................................................................................172
Figure 21-5 Gas Valve Heater and Temperature sensor to FEB ............................175
Figure 21-6 Fuse Box ................................................................................................................175
Figure 21-7 PowerGen with GCU Installed ...................................................................... 176
Figure 21-8 Drum Emptying Valve (Shown in Open Position) ................................177