Qnergy PowerGen 5650 Series, Installation & Operation Manual

Page: 36 / 194

P
OWER
G
EN
I
NTERFACES
24
5.2.2 System Run Light
The system run light is a green-colored light which provides indication of the system state per
the table below.
5.2.3 Warning Light
The warning light is an amber-colored light which is used to indicate if any active warnings exist
in the system per the table below.
Table 5-1 User Interface, System Run Light
Condition Indication Description
ON PowerGen Base
running
Power available
Fast continuous
blinking
PowerGen is
currently starting
Power is not available at this stage
1 short blink every 3
seconds
PowerGen is
currently
deactivating
Power is not available at this stage
3 short blinks every
3.5 seconds
PowerGen is in
standby
May be started either locally or remotely
(depends on condition of ‘Local/Remote’
selector switch)
OFF Not running and
NOT ready to start
A fault may be present (see “Fault Messages,
PowerGen” on page 112) or no power from
internal 12V battery
Table 5-2 User Interface, Warning Light
Condition Indication Description
Off No issues
1 short blink every 3 seconds Low or no gas
pressure
Resets automatically when gas
pressure recovers
2 short blinks every 3 seconds Low coolant level Resets automatically once
coolant is filled
3 short blinks every 3 seconds Bad NTC sensor Triggered by any of the NTCs
Constant light Cold start
preheating needed
Applicable for standard and low
temp start systems
On/off blinks General warning Warning type can be seen
through Lynx or SmartView